AD/G2T1/1 - Induction System Inspection (Cth)

AIRWORTHINESS DIRECTIVE For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.1 (1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

Great Lakes Aircraft Company, LLC Model 2T-1A-1 and 2T-1A-2 Aeroplanes AD/G2T1/1 Induction System Inspection 2/2005

Applicability: Model 2T-1A-1 and 2T-1A-2 aeroplanes that have a Lycoming IO-360-B1F6, AIO-360-B1G6, or AEIO-360-B1G6 engine installed. Requirement: 1. Visually inspect the aircraft induction system drain fitting located in the induction elbow below the fuel injector for blockage or restriction. 2. If the hole is found to be blocked or restricted in the weld area or not drilled through the elbow, as a result of the Requirement 1 inspection, open up the restricted hole or drill a hole in the elbow at the fitting location using a No.10 (0.193 inch) drill. 3. Visually inspect the alternate air door for distortion, heat damage and cracks. 4. If any damage is found as a result of the Requirement 3 inspection, repair or fabricate a new door in accordance with Figure 1, Figure 2 and Figure 3 in this Directive. 5. Visually inspect the aircraft induction system for cleanliness of the air filter, distortion, security and damage from backfire or induction system fire. 6. If the air filter is dirty, if any distortion, damage or lack of security is found as a result of the Requirement 5 inspection, repair, replace or modify all affected components. Note: FAA AD 2004-25-22 Amdt 39-13910 refers. Compliance: For Requirement 1 - Within 25 hours time in service (TIS) after the effective date of this Directive. For Requirement 2 - Before further flight, after the Requirement 1 inspection. For Requirement 3 - Within 25 hours TIS after the effective date of this Directive at thereafter at intervals not to exceed 100 hours TIS. For Requirement 4 - Before further flight, after the Requirement 3 inspection. For Requirement 5 - Within 25 hours TIS after the effective date of this Directive at thereafter at intervals not to exceed 100 hours TIS.