AD/AC/87 - Wing Main Spar Steel Strap Corrosion (Cth)

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY SCHEDULE OF AIRWORTHINESS DIRECTIVES

Twin Commander (Gulfstream/Rockwell/ Aerocommander 500, 600 and 700) Series Aeroplanes

AD/AC/87 Wing Main Spar Steel Strap Corrosion 4/92 DM

Applicability: All 500, 600 and 700 series with the original factory-fitted internal steel strap which reinforces the main spar lower cap. The steel strap was fitted in aircraft serial numbers 1731 and subsequent, but not in the 690C and 695 series which featured an internal aluminium alloy strap.

Note: This excludes aircraft that have had the steel strap replaced, on the assumption that all replacement straps were 301 stainless.

Requirement: 1. Determine whether the strap is made from 4130 or 301 (stainless) steel. The following simple method is suggested.

Run a magnet along the wing lower surface skin, under the main spar, between the fuselage and the engine nacelle. If there is a strong magnetic attraction the strap is made from 4130 steel. Since the 4130 strap is prone to corrosion, it must be inspected in accordance with paragraph 2.

If there is no magnetic attraction the strap is made from 301 stainless steel, which is not as prone to corrosion, and does not have to be inspected. (Note that this does not obviate the need for the aluminium alloy spar caps to be inspected for corrosion under AD/AC/83).

2. Gain access to the 4130 steel strap inside the wing, removing fuel cells and lifting filler blocks as necessary. Visually inspect the exposed areas of the steel strap (in between the main spar lower cap and the next stringer aft) for corrosion, between the side of the fuselage and the engine nacelle.