AD/B737/81 Amdt 1 - Thrust Reverser Control System Inspection and Modification (Cth)

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY SCHEDULE OF AIRWORTHINESS DIRECTIVES

Boeing 737 Series Aeroplanes

AD/B737/81 Amdt 1

Thrust Reverser Control System Inspection and Modification

2/95

Applicability: All Boeing 737-300, -400, and -500 series aircraft not incorporating the intent of Boeing Service Bulletin 737-78-1053.

Requirement: 1. Carry out the test of the thrust reverser specified in the Boeing 737 Maintenance Manual, Section 78-31-00, titled "Auto-Restow Test" to verify proper operation of the thrust reverser Auto-Restow function.

The B737 Maintenance Manual contains test procedures for the Auto-Restow function dependent on thrust reverser modification standard and engine accessory unit configuration. Select the appropriate procedure for the particular thrust reverser/EAU configuration undergoing test.

If any discrepancy is found during this test either rectify the defect before further flight or operate the aircraft in accordance with an approved MEL.

Note: Boeing Message M-7272-94-6132 dated 7 December 1994 refers.

2. Incorporate thrust reverser sync-locks per Boeing Service Bulletin 737-78-1053 Revision 1, Revision 2, or Revision 3.

Incorporation of Boeing Service Bulletin 737-78-1053 is terminating action for Requirement 1 of this Directive. Following modification per S.B. 737-78-1053, subsequent test of the Auto-Restow function is to be in accordance with the requirements specified in the Boeing 737 Maintenance Planning Document (MPD).

Note: FAA AD 94-21-05 also refers.

Compliance: 1. Unless previously accomplished, prior to 31 March 1995, and thereafter at intervals not to exceed 4000 flight hours since the last inspection.