COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY SCHEDULE OF AIRWORTHINESS DIRECTIVES Beechcraft 90 and 65-90 (King Air) Series Aeroplanes AD/BEECH 90/51 Elevator Control System - Inspection and Modification 6/78 Applicability: All models with s/Nos. LJ-114 to LJ-705 and LW-1 to LW-141 with Beechcraft H-14 autopilot installations except those which have incorporated Beech Mod. Kit. No. 90- 9067-15 or later approved revisions. Requirement: 1. To prevent chafing of the elevator cable and possible failure perform the following inspection: (a) Open the aft fuselage belly access door and locate the autopilot elevator servo bellcrank at FS 319.00. (b) Measure the bellcrank and if it measures 10 inches or less no further action is required. (c) If the bellcrank measures 13.5 inches or larger, visually inspect the primary elevator control cable, the pulley bracket at FS 340.00, the autopilot servo cable, and autopilot bellcrank for cable rubbing and condition. 2. If rubbing of the elevator cable is noted, but no damage has occurred: (a) Disconnect and remove the autopilot servo cable. (b) Install a locally fabricated placard in plain view of the pilot indicating "Autopilot inoperative". 3. If fraying of the elevator cable or other damage is noted: (a) Replace the elevator cable and repair or replace any other damaged parts. (b) Accomplish paragraph 2. 4. If not previously accomplished, modify the servo mount of any H-14 elevator autopilot servo having a 13.5 inch diameter or larger bellcrank in accordance with Beech Modification Kit No. 90-9067-15 or later approved revision and remove "Autopilot inoperative" placard. Note: Beechcraft Service Instruction No. 0988 refers. Compliance: 1. Before further flight. 2. Before 1 September 1978.