AD/BELL 47/92 Amdt 5 - Main Rotor Blade Grips (Cth)

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY SCHEDULE OF AIRWORTHINESS DIRECTIVES

Bell Helicopter Textron 47 (All Variants) Series Helicopters

AIRWORTHINESS DIRECTIVE

For the reasons set out in the background section, the CASA delegate whose signature appears below revokes Airworthiness Directive (AD) AD/BELL 47/92 Amdt 4 and issues the following AD under subregulation 39.1 (1) of CAR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

AD/BELL 47/92 Amdt 5

Applicability: All models.

Main Rotor Blade Grips 2/2001 TX

Requirement: 1. Inspect the internal threaded portion of each main rotor blade grip barrel using eddy current procedure DOA/NDI/EC6. Copies of this procedure are available from the Authority.

2. Retire the main rotor blade grips from service before exceeding 5000 hours time in service.

Note: Grip assemblies part number 47-120-252-5 are not approved for use in Australia.

Compliance: Unless the initial inspection is already accomplished, at the threshold of 600 hours component time since new or within 25 hours time in service after 21 December 2000, whichever occurs later. Repeat thereafter at intervals not to exceed 600 hours component time in service until retired in accordance with Requirement 2.