AD/CESSNA 150/47 - Cigar Lighter Wiring (Cth)

AIRWORTHINESS DIRECTIVE For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.1 (1) of CAR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

Cessna 150, F150, 152 & F152 Series Aeroplanes

AD/CESSNA 150/47 Cigar Lighter Wiring 3/2003

Applicability: Model 150 series aeroplanes with serial numbers (S/N) 15065062 through 15075564 and Model A150 series aeroplanes with S/N A15000001 through A15000480.

Requirement: If not previously accomplished; disconnect the wire, at the ammeter or at the electrical system bus as applicable, that connects the bus to the cigar lighter receptacle. (The wire is connected to either the bus side or equipment side of a circuit breaker or to the ammeter). Following the disconnection of this wire either:

1. Reconnect the wire to the electrical bus by using an existing or newly installed circuit protection device that is properly rated to protect the wire gauge used for this circuit, or

b. Disconnect the wire from the lighter receptacle at the opposite end and remove it from the aeroplane, or

c. Protect the wire by insulating its disconnected end, fold this wire end back against the wire bundle in which it is routed and secure it to that bundle.

Note 1: The requirements of this Directive may have been previously accomplished in accordance with FAA AD 79-08-03 Amdt 39-3428.