AD/SF340/75 - Bolt and Bushing Installation at WS 123.38 (Cth)
Federal Register of Legislation
Full text
Select any passage to save a personal note with optional tags.
COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY
SCHEDULE OF AIRWORTHINESS DIRECTIVES
SAAB SF340 Series Aeroplanes
AIRWORTHINESS DIRECTIVE
For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.1 (1) of CAR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.
AD/SF340/75 Bolt and Bushing Installation at WS 123.38 3/2000
Applicability: Model SF340A, serial numbers 004 through 159, and Model 340B, serial numbers 160 through 459; with flap assembly and serial numbers listed below:
- 7257800-507, serial numbers 1258 through 1270.
- 7257800-508, serial numbers 1257 through 1269.
Requirement: Action in accordance with SAAB Aircraft Mandatory Service Bulletin (SB) 340-57- 035, dated 18 January 2000.
Note: LFV AD 1-152 refers.
Compliance: Identification and initial inspection to be accomplished within 800 hours time in service after 23 March 2000. Inspect thereafter at intervals not to exceed 800 hours time in service.
Replacement to be accomplished within 4800 hours time in service after 23 March 2000.
This Airworthiness Directive becomes effective on 23 March 2000.
Background: Some discrepancies have been found in the bolt and bushing installation at WS
123.38. The most likely cause was at implementation of SB 340-57-027. Bushings of incorrect length may have been installed at the forward attachment point to the triangular fitting. Bolts and bushings may also have been installed at the aft attachment point. As a consequence, high bearing stresses may lead to worn bushings, elongated holes, vibrations and cracked flap fittings.
Eugene Paul Holzapfel
Delegate of the Civil Aviation Safety Authority 10 February 2000
The above AD is notified in the Commonwealth of Australia Gazette on 23 February 2000.