AD/SWSA226/88 Amdt 1 - Fuel Boost Pump Wiring (Cth)

AIRWORTHINESS DIRECTIVE

For the reasons set out in the background section, the CASA delegate whose signature appears below revokes Airworthiness Directive (AD) AD/SWSA226/88 and issues the following AD under subregulation 39.1 (1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

Fairchild (Swearingen) SA226 and SA227 Series Aeroplanes

AD/SWSA226/88 Amdt 1

Fuel Boost Pump Wiring 4/2004

Applicability: All Model SA226 and SA227 aeroplanes.

Requirement: 1. If not previously accomplished in accordance with CASA Letter F92/0725, dated 1 October 2000, or CAA(NZ) Emergency Airworthiness Directive DCA/SA226/42 remove each fuel boost pump and inspect the wiring for any sign of exposed wires, chafing or electrical arcing.

2. If any exposed wire, chaffing or arcing is evident repair or replace the wiring in accordance with either the airframe manufacturer's instructions or an approved repair scheme.

Note 1: Before removal of the boost pumps it is necessary to defuel the tank. For the initial inspection, fuel boost pumps should not be used to transfer the fuel out of the tank to be inspected.

Note 2: Following each inspection reinstall the boost pumps in accordance with the airframe manufacturer's maintenance manual ensuring that adequate clearance exists between the boost pump wiring and the fuel check valves.

3. Forward the results from the initial inspection, both positive or negative, to CASA as follows: