AD/CESSNA 525/3 Amdt 1 - Electric Pitch Trim System (Cth)

AIRWORTHINESS DIRECTIVE

For the reasons set out in the background section, the CASA delegate whose signature appears below revokes Airworthiness Directive (AD) AD/CESSNA 525/3 and issues the following AD under subregulation 39.1 (1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

Cessna 525 Series Aeroplanes

AD/CESSNA 525/3 Amdt 1

Electric Pitch Trim System 13/2003 TX

Applicability: Model 525 aeroplanes, serial numbers 525- 0001, 525-0002 and 525-0004 through 525-0159 inclusive, without a Trim PC Board Assembly part number (P/N) 6518351- 8 installed.

Requirement: 1. Unless previously accomplished, disengage the PITCH TRIM circuit breaker located on the left circuit breaker panel and install a tie strap (P/N MS3367-1- 4 or equivalent part number) on the shaft of the PITCH TRIM circuit breaker to prevent the circuit breaker from being engaged.

2. Unless previously accomplished, disengage the AP SERVOS circuit breaker located in the right circuit breaker panel and install a tie strap (P/N MS3367-1-4 or equivalent part number) on the shaft of the AP SERVOS circuit breaker to prevent the circuit breaker from being engaged.

Note 1: Installation of Trim PC Board Assembly P/N 6518351-8, in accordance with Cessna Citation Alert Service Letter ASL525-27-02, dated 10 October 2003, is considered an optional terminating action for Requirements 1 and 2 of this Directive.