AD/G1159/36 - Corrosion and Cracking Fuselage Station 452 (Cth)

COMMONWEALTH OF AUSTRALIA (Civil Aviation Regulations 1998), PART 39 - 105 CIVIL AVIATION SAFETY AUTHORITY SCHEDULE OF AIRWORTHINESS DIRECTIVES

Gulfstream (Grumman) G1159 and G-IV Series Aeroplanes

AD/G1159/36 Corrosion and Cracking Fuselage Station 452 9/90

Applicability: Serial numbers:

001, 002, 003, 005, 006, 007, 008, 010, 011, 012, 013, 014, 015, 017, 018, 019, 020, 021, 022, 023, 024, 025, 026, 027, 028, 029, 031, 033, 034, 035, 037, 038, 039, 040, 041, 043, 044, 045, 046, 047, 049, 050, 051, 052, 053, 055, 056, 057, 059, 061, 063 & 065.

Requirement: 1. Perform a visual inspection to detect corrosion or cracks in the wing rear beam/upper cap angle, wing upper aft plank, and the "clothespin" attach fitting, part number 1159WM20016, located at Fuselage Station 452.

2. Inspect the lower cavity of the "clothespin" attach fitting, using a 4.9 mm or smaller flexible borescope through the existing drain hole. If no drain hole exists, prior to further flight, install a drain hole in accordance with Gulfstream G-II Customer Bulletin No 42, Section V, dated December 15, 1969.

3. Inspect the upper cavity of the "clothespin" attach fitting, using the borescope through the gaps where the "clothespin" mates with the fitting. If foam filler is present and this inspection cannot be accomplished, perform the inspection in accordance with a scheme approved by the Authority.

4. Inspect the wing upper aft plank adjacent to the clothespin fitting for corrosion or defects using pulse echo ultrasonic equipment. (CAUTION: A machined step in this area may be misinterpreted as material loss.)

5. Replace any cracked or corroded parts in accordance with a scheme approved by the Authority.

Note: FAA Emergency AD 90-13-02 refers.