AD/JETSTREAM/94 Amdt 2 - Frame 199 Wing Spigot Post Assembly Bolts (Cth)

AIRWORTHINESS DIRECTIVE On the effective date specified below, and for the reasons set out in the background section, the CASA delegate whose signature appears below revokes Airworthiness Directive (AD) AD/JETSTREAM/94 Amdt 1 and issues the following AD under subregulation 39.001(1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

British Aerospace BAe 3100 (Jetstream) Series Aeroplanes AD/JETSTREAM/94 Amdt 2 Frame 199 Wing Spigot 4/2006 TX Post Assembly Bolts

Applicability: All Jetstream Series 3100 and 3200 aircraft. Requirement: Action in accordance with BAE Systems Service Bulletin 57-JA020740 Revision 2, or later EASA approved revision.

Note: UK CAA AD G-2006-0003 refers. Compliance: Before 31 March 2006, unless already accomplished. Inspect thereafter as specified in the Requirement document. This Amendment becomes effective on 6 March 2006. Background: The manufacturer received reports of failed bolts fitted to frame 199 wing spigot post assembly on in-service aircraft. Investigation revealed fatigue failure, resulting from either incorrect bolts installed or bolt tightening torque being too low. Failure of these bolts severely compromises the structural integrity of the wing to fuselage attachment.

Amendment 1 added an alternative bolt part number and a compliance note, and excluded run-down torque in the torque figures.