Vehicle Standard (Australian Design Rule 29/00 – Side Door Strength) 2006 (Cth)

Vehicle Standard (Australian Design Rule 29/0029/00 – Side Door Strength Side Door Strength) 20062006 Compilation 1

Compilation: 1 (up to and including Vehicle Standard (Australian Design Rule 29/00 – Side Door Strength) 2006 Amendment 1)

Compilation Date: 19 September 2007

Compiled by: Vehicle Safety Standards, Department of Transport and Regional Services.

CONTENTS

A. legislative provisions..............................................

A.1. NAME OF STANDARD...........................................

A.2. COMMENCEMENT..............................................

A.3. REPEAL.......................................................

B. SCOPE.........................................................

C. APPLICABILITY................................................

29.0. DEFINITIONS...................................................

29.1. REQUIREMENTS................................................

29.2. TEST PROCEDURE..............................................

29.3. DETERMINATION OF CRUSH RESISTANCE........................

29.4. ALTERNATIVE STANDARDS.....................................

29.5. EXEMPTION FROM TEST REQUIREMENTS........................

Compilation NOTES.....................................................

A. legislative provisions

A.1. NAME OF STANDARD

A.1.1. This Standard is the Vehicle Standard (Australian Design Rule 29/00 – Side Door Strength) 2006.

A.1.2. This Standard may also be cited as Australian Design Rule 29/00 — Side Door Strength.

A.2. COMMENCEMENT

A.2.1. This Standard commences on the day after it is registered.

A.3. REPEAL

A.3.1. This Standard repeals each vehicle standard with the name Australian Design Rule 29/00 — Side Door Strength that is:

(a) made under section 7 of the Motor Vehicles Standard Act 1989; and