TARIFF CONCESSION ORDER Under Section 269P of the Customs Act 1901, I, Wendy Knowles, a delegate of the Chief Executive Officer declare that the goods specified in Column 1 of THE TABLE are goods to which the item in Part III of Schedule 4 to the Customs Tariff Act 1995 specified in Column 2 of THE TABLE applies. This Order shall have effect from 26.09.06 and continue in force until revoked under sections 269SC or 269SD of the Act, or the date, if any, specified in Column 2. THE TABLE COLUMN 1 COLUMN 2 Description of Goods including the Schedule 4 Item Number Customs Tariff Classification Last date of effect 7210.70.00 STEEL, high polymer polyester coated, complying with Japan 50 Industrial Standard G3312/SGCD1 (JIS G3312/SGCD1) AND European Union Directive 2002/95/EC on the Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment (RoHS), having ALL of the following: (a) epoxy reverse coating adhering to polyurethane; (b) specular gloss level NOT less than 80 units at 60 degrees; (c) distinction of image NOT less than 60 units; (d) surface having ALL of the following: (i) inclusions NOT greater than 0.2 mm over 1 square metre and having proximity NOT less than 400 mm; (ii) dents NOT greater than 0.3 mm over 1 square metre and having proximity NOT less than 400 mm; (iii) leveller bite NOT greater than 20 mm; (e) in ANY of the following sizes: (i) width 607 mm and gauge 0.5 mm; (ii) width 672 mm and gauge 0.5 mm; (iii) width 729 mm and gauge 0.5 mm; (iv) width 732 mm and gauge 0.5 mm; (v) width 774 mm and gauge 0.5 mm; (vi) width 824 mm and gauge 0.5 mm; (vii) width 924 mm and gauge 0.5 mm; For the purposes of this order, tolerances allowable for specification (e) are: (a) width +2 mm; (b) gauge + or - 0.02 mm Op. 26.09.06 - TC 0615052 This is page 1 of 1 Page of the above Table. ..Wendy Knowles........................ Dated 05 February 2007 Delegate of the Chief Executive Officer