TARIFF CONCESSION REVOCATION ORDER Under Section 269SD(2) of the Customs Act 1901, I Robert Crawford a delegate of the Chief Executive Officer (a) revoke Tariff Concession Order Number 8735578 made on 01.01.88, in respect of the goods described in TABLE A below. This Revocation has effect from 01.01.07; and (b) make in its place the Tariff Concession Orders described in TABLE B. The goods specified in Column 1 of TABLE B are goods to which the item in Part III of Schedule 4 to the Customs Tariff Act 1995 specified in Column 2 of TABLE B applies. The Order shall have effect from the date notified in paragraph (a) above as the date of effect for the Revocation. TABLE A COLUMN 1 COLUMN 2 Description of Goods including the Schedule 4 Item Number Last date of effect Customs Tariff Classification 7306.10 TUBES OR HOLLOW BARS (NOT being honed tubes), in straight lengths, 50 ends plain, bevelled or threaded in accordance with ANY of the 31.12.06 following tube, hollow bar or Pipe Material Specification options: (a) AS; (b) ASME; (c) ASTM; (d) BS; (e) DIN, but without further rework, having a length NOT less than four times the OD, as listed in THE TABLE: THE TABLE Outside Dia Wall Thickness (a) NOT exceeding 219.08 mm 13.00 mm or greater but NOT exceeding 25.00 mm; (b) 219.08 mm or greater but 12.70 mm or greater but NOT exceeding 254.00 mm NOT exceeding 50.80 mm; (c) 254.00 mm or greater but 19.05 mm or greater but NOT exceeding 323.85 mm NOT exceeding 41.00 mm; (d) 323.85 mm or greater but 25.40 mm or greater but NOT exceeding 720.73 mm NOT exceeding 75.00 mm Op. 01.01.88 - TC 8735578 This is page 1 of 2 Pages of the instrument. ..Robert Crawford...................... Dated 20 June 2007 Delegate of the Chief Executive Officer Revocation Instrument HS2007/274A TABLE B COLUMN 1 COLUMN 2 Description of Goods including the Schedule 4 Item Number Last date of effect Customs Tariff Classification 7306.19.00 TUBES OR HOLLOW BARS (NOT being honed tubes), in straight lengths, 50 ends plain, bevelled or threaded in accordance with ANY of the following tube, hollow bar or Pipe Material Specification options: (a) AS; (b) ASME; (c) ASTM; (d) BS; (e) DIN, but without further rework, having a length NOT less than four times the OD, as listed in THE TABLE: THE TABLE Outside Dia Wall Thickness (a) NOT exceeding 219.08 mm 13.00 mm or greater but NOT exceeding 25.00 mm; (b) 219.08 mm or greater but 12.70 mm or greater but NOT exceeding 254.00 mm NOT exceeding 50.80 mm; (c) 254.00 mm or greater but 19.05 mm or greater but NOT exceeding 323.85 mm NOT exceeding 41.00 mm; (d) 323.85 mm or greater but 25.40 mm or greater but NOT exceeding 720.73 mm NOT exceeding 75.00 mm Op. 01.01.07 - TC 0614214 This is page 2 of 2 Pages of the instrument. ..Robert Crawford...................... Dated 20 June 2007 Delegate of the Chief Executive Officer Revocation Instrument HS2007/274A