AD/ARRIEL/31 - Reduction Gear Box Intermediate Pinion (Cth)

AIRWORTHINESS DIRECTIVE For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.001(1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

Turbomeca Turbine Engines - Arriel Series AD/ARRIEL/31 Reduction Gear Box Intermediate Pinion 3/2009

Applicability: Arriel 1B, 1D and 1D1 turboshaft engines, all serial numbers.

Note 1: These engines are known to be installed on, but not limited to, Eurocopter AS 350 B, AS 350 BA, AS 350 B1 and AS 350 B2 helicopters. Requirement: Replace the Reduction Gear Box Intermediate Pinions (P/N 0 292 70 779 0) with Pinions incorporating Turboméca modification TU 232 in accordance with Turboméca Mandatory Service Bulletin 292 72 0276 Version B dated 6 November 2008 or later approved revision.

Note 2: EASA AD 2009-0002 dated 7 January 2009 refers. Compliance: No later than 28 February 2011, unless previously accomplished. This Airworthiness Directive becomes effective on 12 March 2009. Background: Several events of rupture of the Arriel 1 Reduction Gear Box Intermediate Pinion have been reported in service. The ruptures have been determined to be originated at the pinion teeth root due to increased vibratory stresses. This increase in vibratory stresses is mainly caused by increased teeth wear over engine life time.