AD/A109/62 - Engine - Power Turbine Speed - Operational Limitation (Cth)

AIRWORTHINESS DIRECTIVE For the reasons set out in the background section, the CASA delegate whose signature appears below issues the following Airworthiness Directive (AD) under subregulation 39.001(1) of CASR 1998. The AD requires that the action set out in the requirement section (being action that the delegate considers necessary to correct the unsafe condition) be taken in relation to the aircraft or aeronautical product mentioned in the applicability section: (a) in the circumstances mentioned in the requirement section; and (b) in accordance with the instructions set out in the requirement section; and (c) at the time mentioned in the compliance section.

Agusta A109 Series Helicopters AD/A109/62 Engine - Power Turbine 4/2009 TX Speed - Operational Limitation

Applicability: Agusta S.p.A. A109A, A109AII and A109C helicopters, all serial numbers if equipped with Rolls-Royce Corporation (formerly Allison) engine model 250-C20B or 250-C20R/1 with a third stage turbine wheel having part number (P/N) 23065833 installed. Requirement: Accomplish the requirements specified below in accordance with the instructions of Agusta BT 109-129 dated 16 February 2009.

1. Avoid steady-state operation in the 95-97% N2 range for more than 60 seconds in single or cumulative events. If steady-state operation in the 95-97% N2 range exceeds 60 seconds in single or cumulative events, before further flight perform specific corrective actions as per Rolls-Royce CEB A-1400 Rev. 3.

Note 1: Steady-state operation is defined as any manoeuvre during which an attempt is being made to maintain a constant engine speed within 2% N2.

2. Install on the instruments panel below or near the "ENGINE & ROTOR RPM POWER TURBINE (N2)" indicator, in an area visible by the pilot(s), one of the two decals (depending on the applicable instruments panel configuration) shown in figure 1 of Agusta BT 109-129 reporting the following text: