Competition and Consumer Act 2010 - Consumer Protection Notice No. 5 of 2012 - Imposition of Permanent Ban on Small, High Powered Magnets (Cth)

COMMONWEALTH OF AUSTRALIA

COMPETITION AND CONSUMER ACT 2010

Consumer Protection Notice No. 5 of 2012

IMPOSITION OF PERMANENT BAN ON SMALL, HIGH POWERED MAGNETS

I, DAVID BRADBURY, Assistant Treasurer:

pursuant to section 114(1) of the Australian Consumer Law, IMPOSE a permanent ban on consumer goods of a kind specified below. This permanent ban comes into force on the day after this Notice is registered on the Federal Register of Legislative Instruments.

Particulars of Consumer Goods

Separable or loose magnetic objects that are supplied in multiples of two or more where: a. at least two of those magnetic objects are each separately able to fit entirely, in any orientation, into the small parts cylinder as provided by clause 5.2 and figure 15 of the Australian / New Zealand Standard, Safety of toys – Part 1: Safety aspects related to mechanical and physical properties (AS/NZS ISO 8124.1:2010) and b. at least two of those magnetic objects each separately have a magnetic flux index greater than 50 (kG)2 mm2, determined as per clause 5.31 of AS/NZS 8124.1:2010 and c. the magnetic objects are marketed by the supplier as, or supplied for use as, i. a toy, game or puzzle (including but not limited to an adult desk toy, an educational toy or game, a toy, game or puzzle for mental stimulation or stress relief); or ii. a construction or modelling kit; or iii. jewellery to be worn in or around the mouth or nose.

Interpretation

Construction or modelling kit This ban is subject to the definition of consumer goods provided in section 2 of the Australian Consumer Law. This means that a construction or modelling kit containing small high powered magnets which is not used, or likely to be used, for personal, domestic or household use will not be subject to this permanent ban.

Magnetic flux index 50 (kG)2 mm2 is equivalent to 0.5 T2m2. This measure is determined as per clause 5.31 of AS/NZS 8124.1:2010. In clause 5.31.3, omit "kG2mm2" and replace with (kG)2 mm2.