Vehicle Standard (Australian Design Rule 19/01 – Installation of Lighting and Light-Signalling Devices on L-Group Vehicles) 2007 (Cth)

Vehicle Standard (Australian Design Rule 19/01 – Installation of Lighting and Light-Signalling Devices on L-Group Vehicles) 2007

made under the

Motor Vehicle Standards Act 1989

Compilation: 1 (up to and including Vehicle Standard (Australian Design Rule 19/01 – Requirements for Installation of Lighting and Light-Signalling Devices on L-Group Vehicles) 2007 Amendment 1)

Compilation Date: 16/04/2016

Compiled by: Vehicle Safety Standards, Department of Infrastructure and Regional Development.

CONTENTS

0. legislative provisions 1. SCOPE 2. APPLICABILITY AND IMPLEMENTATION 3. DEFINITIONS 4. REQUIREMENTS 5. EXEMPTIONS AND ALTERNATIVE PROCEDURES 6. SUPPLEMENTARY GENERAL REQUIREMENTS 7. SUPPLEMENTARY INDIVIDUAL SPECIFICATIONS 8. ADDITIONAL REQUIREMENTS 9. ALTERNATIVE STANDARDS 10. NOTES APPENDIX A COMPILATION NOTES

0. legislative provisions 0.1. Name of Standard 0.1.1. This Standard is the Vehicle Standard (Australian Design Rule 19/01 – Installation of Lighting and Light-Signalling Devices on L-Group Vehicles) 2007. 0.1.2. This Standard may also be cited as Australian Design Rule 19/01 – Installation of Lighting and Light-Signalling Devices on L-Group Vehicles. 0.2. Commencement 0.2.1. This Standard commences on the day after it is registered. 0.3. Repeal 0.3.1. This Standard repeals and replaces Vehicle Standard (Australian Design Rule 19/01 – Installation of Lighting and Light-Signalling Devices) 2006 1. SCOPE This vehicle standard prescribes requirements for the number and mode of installation of lighting and light-signalling devices on L-group vehicles. 2. APPLICABILITY AND IMPLEMENTATION 2.1. This vehicle standard applies to the design and construction of vehicles as set out in the table below. 2.2. These vehicles must have their lighting and light-signalling devices installed to comply with the relevant requirements of this vehicle standard or with an acceptable prior rule as set out hereunder. 2.3. Where the fitment of a lamp is indicated as optional, this means that it is not mandatory to fit the lamp but, if fitted, the lamp(s) are required to comply. 2.4. Vehicles certified to any of the "Acceptable Prior Rules", as shown below in the applicability table for a particular vehicle category, are deemed to comply with this rule. 2.5. Vehicles certified to ADR 67/... need not comply with this rule.