Vehicle Standard (Australian Design Rule 93/00 – Forward Field of View) 2018 (Cth)

Vehicle Standard (Australian Design Rule 93/00 – Forward Field of View) 2018 I, ANDREW BROAD, Assistant Minister to the Deputy Prime Minister, determine this vehicle standard under section 7 of the Motor Vehicle Standards Act 1989.

Dated 25 October 2018

[SIGNED]

Andrew Broad

Assistant Minister to the Deputy Prime Minister

CONTENTS

1. legislative provisions.............................................3 2. FUNCTION....................................................3 3. APPLICABILITY...............................................3 4. DEFINITIONS..................................................5 5. requirements....................................................5 6. exemptions and alternative procedures...............................5 7. alternative standards..............................................6 APPENDIX A.........................................................7

1. legislative provisions 1. Name of Standard 1. This Standard is the Vehicle Standard (Australian Design Rule 93/00 – Forward Field of View) 2018. 2. This Standard may also be cited as Australian Design Rule 93/00 – Forward Field of View. 2. Commencement 1. This Standard commences on the day after it is registered.

2. FUNCTION 1. The function of this vehicle standard is to ensure the driver has an adequate field of view to either side and in all directions in front of the vehicle.

3. APPLICABILITY 1. This vehicle standard applies to category L, M and N vehicles from the dates set out in in clauses 3.1.1 to 3.1.2 and the table under clause 3.3 below. 1. 1 July 2019 for all new model vehicles. 2. There is no mandatory application date for all other vehicles. They may comply with this vehicle standard, or continue to comply with the Australian Design Rule 42/04 – General Safety Requirements. 2. For the purposes of clause 3.1.1, a "new model" is a vehicle model first produced with a 'Date of manufacture' on or after the agreed date in that clause.