Vehicle Standard (Australian Design Rule 19/02 – Installation of Lighting and Light Signalling Devices on L-Group Vehicles) 2005 (Cth)

`

Vehicle Standard (Australian Design Rule 19/02 – Installation of Lighting and Light Signalling Devices on L-Group Vehicles) 2005 Made under section 12 of the Road Vehicle Standards Act 2018

Compilation: 2 (up to and including Vehicle Standard (Australian Design Rule) Lighting Standards Amendment Instrument 2022 (No.1))

Compilation Date: 20 January 2023

Compiled by: Vehicle Safety Policy and Partnerships, Department of Infrastructure, Transport, Regional Development, Communications and the Arts

CONTENTS 1. NAME OF STANDARD..............................................3 4. SCOPE............................................................3 5. APPLICABILITY AND IMPLEMENTATION.............................3 6. DEFINITIONS......................................................4 7. REQUIREMENTS...................................................4 8. EXEMPTIONS AND ALTERNATIVE PROCEDURES.....................4 9. SUPPLEMENTARY GENERAL REQUIREMENTS........................5 10. SUPPLEMENTARY INDIVIDUAL SPECIFICATIONS.....................6 11. ADDITIONAL REQUIREMENTS......................................8 12. ALTERNATIVE STANDARDS.......................................10 13. NOTES...........................................................11 APPENDIX A.........................................................12 COMPILATION NOTES.................................................55

1. NAME OF STANDARD 1. This Standard is the Vehicle Standard (Australian Design Rule 19/02 – Installation of Lighting and Light Signalling Devices on L-Group Vehicles) 2005. 2. This Standard may also be cited as Australian Design Rule 19/02 — Installation of Lighting and Light Signalling Devices on L-Group Vehicles. 4. SCOPE This vehicle standard prescribes requirements for the number and mode of installation of lighting and light-signalling devices on L-group vehicles. 5. APPLICABILITY AND IMPLEMENTATION 5.1. This national standard applies to the design and construction of vehicles as set out in the table below. 5.2. These vehicles must have their lighting and light-signalling devices installed to comply with the relevant requirements of this national standard or with an acceptable prior rule as set out hereunder. 5.3. Where the fitment of a lamp is indicated as optional, this means that it is not mandatory to fit the lamp but, if fitted, the lamp(s) are required to comply. 5.4. Vehicles certified to any of the "Acceptable Prior Rules", as shown below in the applicability table for a particular vehicle category, are deemed to comply with this rule. 5.5. Vehicles certified to ADR 67/... need not comply with this rule.